www.jpmagazine.com - forums

Trading out my first suspension part tomorrow and looking forward to it, nuts already broke loose, lots of PB. Trading out my old worn out OEM track bar for an OEM Moog, on my 96 XJ. First question. The trucks up on ramps right now. With that in mind, should I expect any kind of lurching when I

Its a long story but to sum it up my dealership REALLY screwed up and for an appology I am receiving a set of the Mopar Rock Rails with functional heavy duty Tubular Rub Rail. [img]http://moparestore.trademotion.com/moparImages/Accessory%20Catalog/Images/Image%20Parts/MA_VEH_82210574___T001.jpg[/im

I send you my renewal notice to continue subscription a few months ago. it took about about a month in a half of so to recieve my bill. In which it read that it was the second notice. But i had not recieved my first at the time. I paid it on last month. and now i had recieved my third notice, for re

Just wanting to make sure I'm not getting ripped off here. Here's one of my front u-joints... [img]http://i287.photobucket.com/albums/ll148/jeepin_photo/4.jpg[/img] My mechanic is telling me both u-joints need to be replaced specifically b/c of the ring of rust that coats where the center piece a

I changed the intake on my 4.2 and the 4bbl intake does'nt have a location for the temp gauge prob is there another location for it

I have a 1998 Grand limited quad. I have the pan off of the trans. right now, just replaced the stock filter with a fram. The fram is too thick, and keeps the pan from being put back on. Can anyone help me out? Wrong filter? Momentary retardedness? Overlooking something? Filter is exactly the same b

Here is a shot right after I moved to Colorado. I was having some issues coming up this obstacle on Chinaman. I bet that Flashpaq will get me some ponies back! Even more after I finish building the 4.6 stroker! [img]http://lh6.ggpht.com/_tHSwOqbDUnY/TDVB6kGa9YI/AAAAAAAABqE/YCMknL-T_L4/s640/Chinaman%

The event will be from 9am to 9pm. Jeep Games begin 3pm to 8pm. There will a Shine and Show. RTI ramps,Offroad clubs, awards and prizes for different catagories (ugliest, tallest, best in show and so forth) Win Jeep accessories,offroad passes,plaques and other prizes. ALL Jeep models welcome. So com

I currently have a '05 Wrangler Unlimited Rubicon with Rough Country Nitro 9000s on it. This is the second pair of rear shocks that have gone bad in 6 months. The jeep has 2.5in. aluminum spacers and 33x12.5 tires. I also had the previous pair of shocks on an '04 Wrangler with similar specs and got

I've got a '98 TJ with a Pro Comp 4" lift and 33 All Terrian tires. I've added a Currie Rock Jock Heavy Duty tie rod and drag link assembly, and a very stout track bar. When driving on the open road the steering wheel has a lot of loose travel. There is about a quarter (may be a little less) revolut

i have a 2006 wrangler x with a 6 speed manual transmission, with 47000 miles on it, the jeep has 4 inch lift and a 33 inch tires. i recently did a slip yoke eliminator kit. after doing this i began to hear alot of drive line noise. i took the transfer case back out and rebuilt it again to make sure

Looking for info on good after market street suspension, shocks that give good road ride, but are more concerned about handling, cornering on the street.

I purchased an 07 Wrangler X new and have changed the 5W20 recommended oil about every 5,000 mile since it was new. Very little off roading on this vehicle and I changed the air filter 3 times in its current 65,000 miles. For the first year I used a Jeep dealership for service and had some minor i

Case is dripping fluid from the 3/16 hole in front. Why?

i have a question regarding my 02 wrangler i have had the 2" bb kit on it for about two years now and im noticing that its starting to get bad vibes in the front end around 45-60 mph its worse when im slowing than when im going if you get what im sayin and i just got it aligned by a creditable sho

I installed a DUI HEI awhile back it works great, however, it would appear that I have a substantial range with my timing, from 5 to 13 degrees BTDC. Will the proper or improper timing (increasing or decreasing) have an impact on my oil pressure? Since installing the HEI the best Oil pressure wi

Been diagnosing my steering problems under my 96 Cherokee and today I found I've got some play at my pitman arm / drag link union. Does this mean I need to replace both the pitman arm and the drag link end, or do I just need to replace the drag link end? Additionally I may need to replace my tie r

I have for sale brand new floor pans for the driver side front and rear. I am looking to sell them for $100 for both. Shipping would be an additional cost at your expense. I'm located in Buffalo, N.Y. The best way to contact me is my cell. My name is Mike and the number is (716)- 796- ONE ONE FIVE

I have for sale a pair of rocker panels for the XJ Cherokee. I have two driver sides but i believe the other one could be modified to fix other side. I'm looking to get $60 for the pair. Shipping would be an additional cost at your expense. These are stock replacements that are located underneath th

New Rocker Panels- stock replacements. I have two driver sides. Other one can be modified to fix other side. I'm looking to get $60 for the pair, plus shipping costs. I'm located in Buffalo, N.Y. The best way to contact me is on my cell. My name is Mike and my number is (716)-796- ONE ONE FIVE THREE