Jeep Forums

I am looking to level my 07 JK. What is the lift size I will need to make it level and which is the best all around coil spacer available? Thanks

I am looking to level my 07 JK. What is the lift size I will need to make it level and which is the best all around coil spacer available? Thanks

looking for some information, I bought many years ago a jeep , not knowing anything about it accept it was a jeep, have since been told it is a cj t18 granny package, it has a v 8, tilt streeing , and a t 18 transmission. I am told these are somewhat rare, just tring to find out the skinny on this

finally gave up on my 94 yj with the 4banger i love that jeep but its time to move on to bigger and better andi found an 02 sahara i have had my eye on for the last week i get to look at it tomorrow to make the final decision after crawling around and under it and driving it hopefully all goes well

HOPE SOME OF YOU JEEP GUYS CAN HELP ME!I HAVE A 1994 GRAND CHEROKEE, WITH 250,000 MILES ON IT.IT HAS THE 4l ENGINE,AUTOMATIC,QUADRATRAC.WHEN I TURN THE KEY TO "ON",THE "AIR BAG" AND "SEAT BELT" LIGHTS COME ON,BUT NO "CHECK ENGINE" LIGHT, AND NO FUEL PUMP SOUNDS.THE AIR BAG AND SEAT BELT LIGHTS GO OU

I have a 2001 Cherokee with auto transmission. I want to put in an NV3550. The guys at the Jeep dealer say there are several electronic components on the engine I will need. They also said it was too difficult of a swap and they wouldnt do it. Weenies. So what all will I really need?. Will I need a

I have a 75 CJ5 with a 304 V8 T-150 3 speed and Dana 20 transfer. Transfer case has a lot of slop between the gears. I can get to all the gears but the excessive play concerns me. Did some research and it seems to be the linkage I found a replacement on CATO CTIN JEEP the part comes in two lengths

Just wanted to say i got my 3 rd pair of fenders a week ago, because the first two started rusting and powdercoat fell off in about a month. So they sent me a third pair great but didnt want to take off and put on agin just for them to rust again so had them line x and the guy called me when he open

22 Comments, last updated on Wednesday Aug 25 by doc1120

3 Comments, last updated on Wednesday Aug 25 by Joe Dirt

1 Comment, last updated on Wednesday Aug 25 by Linda

I'm need some ideas on upgrading the front of the YJ; I want to do the Ford 8.8 3.73 Aussie Locker in the rear, but I'm not sure what to do with the front. I'm of coarse looking for the most economical upgrade to match the 3.73 rear.Advice is always appreciated! Currently 91YJ.4.O HO, Dana 35/30 3.0

HELLO, I HAVE A FRIEND WHO HAS AN 86 XJ SHE GOT FOR CHEAP.ITS GOT THE CAD SYSTEM STILL ON IT AND ITS IN GREAT SHAPE..IS THERE A DECENT CAD DIAGRAM OUT THERE..IT LOOKS AS IF SHES GOT A HOSE THATS SHEARED OF NOT SURE WHERE IT GOES..4 WD IS NOT FULLY ENGAGING...I KNOW IT SHOULD BE SWITCHED OUT BUT TH

OK, so here's the story-- I need quite a bit of help, on several topics, on a recently acquired Jeep CJ. First- looks like a CJ6, people here sasy it's a CJ6, bill of sale says CJ5. Vin# is J3F845VE15895 if that helps any. Second- I know very little about this Jeep- so any info you all might be

I have a '79 D50 that the previous owner has swapped a dana 30 in and when I purchased the truck he said it was a front axle from a jeep. I asked him from what specifically and he couldn't remember. I've done a lot of research to try to find out what it came from but with no luck.(no casting numbers

why does my a/c come on with my defroster i always unhook my a/c in winter and never noticed it comes on with defroster maybe a stupid question but id like to know 02 wrangler sport 4.0/ 5 speed

Ok in always reading about in The mag the d30 d35 suck if we run a tire bigger then a 33" tire I've alrdy taco'ed my D30 in my LJ and I know the D60 is the superman of it light duty truck axle so here'sy question! I know currie and Dana and ford and spidertrax etc all make these killer awsome axle

I was told by my local tire guy that siping the inner lugs on my BFG Muds will add 15% of life to the tires. I know siping gives longer life but 15%. I have also been told they will grip better on ice and snow. I can have them siped for $15 a tire. Why doesn't everyone sipe their tires. Any inf

I have a 1990 yj with the 4.6 stroker.my torque converter has come apart.the tranny is a 3 speed automatic.I would like to go with something with overdrive.The jeep is a every day driver,with a lot of time on the interstat.don't want to spend money on 3 speed then change out later.what is the best t

4 Comments, last updated on Monday Aug 23 by DD BOOTS